Korg modwave - Windows

Installation
5
Windows
To install the soware on Windows 10 or later (earlier versions are not supported):
1. On the modwave, make sure that the USB Network parameter is set to NCM.
For more information, see “USB Network must be set to NCM” on page4.
2. Double click “Korg modwave Editor/Librarian [version number] Installer.exe.”
e installer will start.
3. Follow the on screen instructions to complete the installation.
e installation will run, including the Editor/Librarian application, Apple Inc.’s Bonjour, and NCM networking
support (using standard Windows drivers).
4. Connect your modwave to the computer via USB.
In some cases, the modwaves may not be immediately recognized aer installation. If this occurs, simply restart your
computer.