Korg modwave - Editing Scales

Using the Librarian
17
You can select two or more non-continuous Slots using command-click on MacOS, or Ctrl-click in Windows.
Alternatively, select a continuous range of Slots by using Shi-click.
2. Select the Cut, Cut and Shi Slots, Copy, or Delete command, as desired.
You can either select the commands from the Edit menu, or bring up the contextual menu by right-clicking/control-
clicking on one of the selected Slots. For details on how these work, especially Cut and Shi Slots, see “Edit menu” on
page25.
If you delete a Slot, its contents are replaced by the Init Performance.
If using Paste or Insert Before, continue:
3. Select the destination Slot.
Important: if multiple Slots are selected, only the lowest-numbered selection aects the Paste or Insert Before
operation; other selections are ignored. For more information, see “Paste” on page25 and “Insert Before” on
page26.
4. Select the Paste or Insert Before command, as desired.
Using drag-and-drop
To re-arrange Slots using drag-and-drop:
1. Select the Slots that you’d like to copy or cut.
2. Click and drag on top of a Slot to Paste, or to the space between Slots to Insert Before.
e eect on the original Slots depends on whether or not you hold the Option key (MacOS) or Alt key (Windows),
and whether you’re dragging within a single Set List or from one Set List to another, as shown in the table below.
Destination Drag action Edit action Aect on Original Slots
Same Set List
On top of a Slot Paste Changed to Init Performance
On top of a Slot, holding Option/Alt Paste Remain unchanged
Between Slots Insert Before Removed, as with Cut and Shift Slots
Between Slots, holding Option/Alt Insert Before Remain, shifted down with the rest of the Slots
Dierent Set List
On top of a Slot Paste
Original Slots always remain unchanged
Between Slots Insert Before
Note that dragging to a dierent Set List always leaves the original Slots intact; option-drag is not required.
Editing Scales
To edit Scales:
1. Go to the Librarian window.
2. Set FILTERS (at the top of the le panel) to Scales.
e main section of the window will change to show the installed Scales.
3. Double-click on an unlocked Scale, or right-click on an unlocked Scale and select Open Scale Editor from the
contextual menu.
Only unlocked user Scales can be edited. To create an editable version of a locked, factory scale, right-click on
the Scale and select Duplicate from the contextual menu.
4. Edit the scale as desired; see “Scale settings,” below.
5. Press Save to save the edited scale, or Cancel to exit and discard the changes.
Important: Save always overwrites the existing Scale data, even if you change the name. To create a new Scale,
use the Duplicate command rst, and then edit the duplicate Scale.
Scales are saved with the “korgscale” extension, and can be shared between the wavestate and modwave.