Reference Guide
119
Reference Guide
Effect
Parameters
4
With the Parallel 3 placement, buses A and B are sent straight to the outputs. Bus C signal is sent
to Effect1 and bus D signal is sent to Effect2. The effect outputs, each with independent level
control, are then mixed down to the L/MONO and R outputs. This placement works well when
playing GM compatible songs.
21A Copy Effects
This function allows you to copy the effect parameter settings from a Program, Combination, or
song to the currently selected Program, Combination, or Multi setup.
To copy effect parameters, select the effect copy source and the source number using the [
√
] and
[®] keys, position the cursor on OK?, then press the [
▲
] button. The message “Are You Sure OK?”
appears. Press the [
▲
] button to continue, or the [
▼
] button to cancel. The effect parameters are
copied to the currently selected Program, Combination, or Multi. Pan, Send C, and Send D
settings, which are set for oscillators, Timbres, and tracks, are not copied.
Note:
For Serial, Parallel 1, and Parallel 2 placements, if Pan 3 or Pan 4 is set to off, signals
sent to bus C and bus D are not output.
LCD Parameter Range Description
21A
Effect Copy Source
PROG
COMBI
MULTI
Select the effect copy source
Source Number
Programs
A00–A99
G01–136
Select the source number
Combinations 00–99
OK to copy OK? Executes effect copy
21A COPY EFF
PROG A00 OK?
21A
To Next Page
Loading...
Need help?
General
