water/alcohol and a lint-free cloth to make it dry and free of dust, oil, etc.
③
Remove the protective film of the windshield electrostatic sticker, then
attach it to the mounting position.
Note:
1. Use an electrostatic sticker, 3M tape may not leave mark after removing.
2. Make sure air bubbles between the sticker and windshield are removed.
④
Remove the protective film of the mount's 3M sticker, and then press
the 3M mount firmly to the center of the electrostatic sticker.
Note:
1. Don’t insert/remove TF card when the device is on.
2. The dash cam should install in positions that won't obstruct driver's field of
view. It is recommended to install behind the rear view mirror in vehicles.
3. Avoid to fix the camera in the black particle area on the front windshield.
4. Make sure camera view won’t be obstructed by sun visor or other objects.
5. Must tear off protective films on camera lens to avoid videos/images fuzzy.
2.2 Connect GPS Module
① Plug the cable of GPS antenna into the USB port on the dash cam.
② Connect the car charger/hardwire kit into USB port on GPS module.
③ Fix or hide the GPS module to a position that won’t block the field of
view of driver and camera. (As shown in figure)
To Next Page
Loading...
