BA 35203_04 * 3.0 * 35203_04_04_Inbetriebnahme_04.fm 4-39
Putting into operation 4
E
Indicator display – steering synchronization
Continuously flashes during the synchronization
process and appears permanently if the parallel
alignment of the wheels on both axles has occurred
– see chapter 5 “Synchronising the steering system”
on page 5-3.
Indicator display – front axle steering
Illuminates if front axle steering is enabled
– see chapter 5 “Front axle steering” on page 5-6.
Indicator display – 4 wheel steering
Illuminates if 4 wheel steering is enabled
– see chapter 5 “4 wheel steering” on page 5-5.
Indicator display – diagonal (crab steering) (option)
Illuminates if diagonal steering is enabled
– see chapter 5 “Diagonal steering (crab steering
option)” on page 5-7.
F
Indicator display – 3rd control circuit in jog mode
Appears if the 3rd control circuit is enabled in jog mode
– see chapter 5 “3rd control circuit” on page 5-40.
Indicator display – continuous operation of 3rd
control circuit (option)
Appears if the 3rd control circuit is enabled in
continuous operation – see chapter 5 “Putting an
attachment into continuous operation” on page 5-43.
Indicator display – additional control circuit in jog
mode (option)
Appears if the additional control circuit is enabled in
jog mode – see chapter 5 “Additional front/rear
control circuit (option)” on page 5-44.
Indicator display – additional control circuit in
continuous mode (option)
Appears if the additional control circuit is enabled in
continuous operation
– see chapter 5 “Additional front/rear control circuit
(option)” on page 5-44.
Indicator display – lock for operating hydraulics/
road travel
Appears if the lock for operating hydraulics/road
travel is enabled with switch 89.
➥ The complete operating hydraulics is switched off
– see “Securing the control lever (joystick)/switching
off the operating hydraulics” on page 4-54.
To Next Page
Loading...
