Kramer 8115

5-46 BA 35203_04 * 3.0 * 35203_04_05_Bedienung.fm
5 Operation
Putting the front/rear additional control circuit into permanent
operation
Before connecting the flexible line to the machine:
• Pick up the attachment and safely lock it
– see “Pick up the attachment” on page 5-58,
– see “Locking the attachment” on page 5-41.
• Lower the loader unit and apply the parking brake.
• Stop the engine, but do not switch off ignition.
• Release the pressure at the plug couplings
– see “Releasing the pressure at the plug couplings” on page 5-66.
• Switch off the starter and remove the starting key.
Fig. 147
B CA
D
G
H
A
B
91
90
2
1
89
F
V
4
Additional front/rear control circuits (38 l/min – 10.04 gal/min)
1. Connect the hose pipes of the
attachment to the coupling connections
A+Bat the front or G + H at the rear.
2. Turn changeover tap D to position 1
(front) or 2 (rear).
3. Slide the lock in switch 89 downward
and press the switch to position A.
4. Slide the lock in switch 91 downward
and press the switch to position B.
➥ Control display F/4
appears.
➥ Pressure is applied to
coupling connections
B(front) or H(rear).
➥ No pressure is applied to
coupling connections
A(front) or G (rear).
Additional front control circuit (115 l/min – 30.38 gal/min)
1. Connect the hose pipes of the
attachment to coupling connections A +
B (front) on the distributing block.
2. Turn changeover tap D to position 1
(front).
3. Slide the lock in switch 89 downward
and press the switch to position A.
4. Slide the lock in switch 90 downward
and press the switch to position B.
5. Slide the lock in switch 91 downward
and press the switch to position B.
➥ Control display F/4
appears.
➥ Pressure is applied to
coupling connection B
(front) .
➥ Coupling connection A
for return.