Kramer 8115

BA 35203_04 * 3.0 * 35203_04_07_Wartung.fm 7-5
Maintenance 7
Check the diesel particulate filter (optional) for ash
load, replace if necessary.
10
Every 3,000 hours of opera-
tion●
Check battery charge condition; and charge if
necessary.
11
● ●●
Heater: Clean the fine-dust filter (replace every
500 hours of operation)
●● ● ●
Check and set the pressure (control piston M3 on the
high-speed gear) (optional).
12
●
Check the brake pads on the service brake and
parking brake and adjust or renew as required
Replace if necessary.
13
●●●
Perform tire check
(damage, inflation pressure, tread depth).
●
●● ● ●
Electrical system: check electric and ground connections,
chafing on wiring harnesses, battery terminals.
●
●● ● ●
Compressed-air brake (option): check for leaks
(sound of escaping air) and damage.
●● ● ●
Check condition of ball hitches (option).
Replace them if necessary.
13
●● ● ●
Aggressive media (option): check anti-corrosion
protection and renew it if necessary.
●● ● ●
Warning and notice signs:
check for damage, readability.
●
● ●●●
Check condition of paint coating. ●
●●●
1. Have the 1st inspection at 100 hours of operation and the 2nd inspection at 500 hours of operation performed by an authorized service center otherwise
warranty claims will not be acknowledged
2. When using bio oil in particular, check for condensation water (oil probe) and replace the hydraulic oil if necessary.
3. Replace every 2 years.
4. Clean the cooling system with clean water before refilling the cooling system.
5. Do not mix the brake fluid with other brake fluids for safety reasons. Use only ATF brake fluids.
6. For the test report, refer to the system manual of machine model 352-03/352-04.
7. Clean radiator more frequently depending on operation and dust conditions, in particular if the machine is used for mowing and mulching applications.
8. Have the pressure accumulators checked only by an authorised service centre (acknowledgement of warranty claims).
9. Must be replaced every 3000 o/h by an authorized service centre.
10. After checking or replacing the diesel particulate filter, reset the requirement in the digital display to zero.
11. Make a note of the date the battery is charged.
12. The pressure at the control piston M3 must be set to 115/-2 bar by an authorized service center every 100 hours of operation.
13. Safety part! Have maintenance and repairs performed only by an authorised service centre
Inspection work
1
() :
Service
centre
User/operator Service centre
Delivery
inspection
Every 10 o/h
(once a day)
Every 20 o/h
“A”
1st Inspection
at 100 o/h
“B” 2nd Inspection
then every
500 o/h
“C”
every 1500 o/h
once a year