4-20 BA 35203_04 * 3.0 * 35203_04_04_Inbetriebnahme_01.fm
4 Putting into operation
Enabling the immobilizer
1. Apply the parking brake – see chapter 5 “Parking brake” on page 5-16.
2. Stop the engine – see “Stopping the engine” on page 4-60.
3. Remove the starting key (blue).
➥ The immobilizer is enabled in 30 seconds.
The drive interlock remains disabled if the ignition key (blue) is not
removed from the ignition lock!
Disabling the immobilizer
• Insert the ignition key (blue) into the ignition lock.
➥ The immobilizer is disabled after 5 seconds.
• Start the engine – see “Starting the engine” on page 4-58.
Deleting coded keys
Deleting coded keys (blue) is necessary whenever a key is lost.
1. Switch on the side marker lights
– see chapter 5 “Parking lights/low beam” on page 5-25.
2. Insert the master key (red) into the ignition lock, turn it to position (2)
and leave it in this position for at least 20 seconds.
➥ All coded keys (blue) are deleted and can be re-coded
– see “Coding the ignition keys” on page 4-19.
The code of the master key (red) is retained.
To Next Page
Loading...
