Kramer KIT-400

Kramer Electronics Ltd.
KIT-400 – Using Embedded Webpages
49
Selecting Panel Model
To select the panel model:
1. In the Navigation pane, click Automation. The Automation page appears (see
Figure 29).
2. Click the Panel tab. The default KIT-400 Device Control Panel appears (see Figure 31).
3. Click Edit. Edit Panel window appears, showing the General Properties area.
You can also access General Properties by clicking the background panel area.
Figure 32: Automation Page – Editing Panel Window
4. From Panel Model drop-down list (in General Properties), define the panel model.
If Custom is selected, set Panel Size (in pixels).
5. Click Save Changes.
Panel model is defined.