Kramer VP-734

14
VP-734 - Connecting the VP-734
5.3 Connecting the Balanced/Unbalanced Stereo Audio
Output
Figure 5: Connecting the Balanced
Stereo Audio Output
Figure 6: Connecting an Unbalanced Stereo
Audio Acceptor to the Balanced Output
5.4 Connecting the VP-734 via the ETHERNET Port
You can connect to the VP-734 via Ethernet using either of the following methods:
 Directly to the PC using a crossover cable (see Section 5.4.1)
 Via a network hub, switch, or router, using a straight-through cable (see
Section 5.4.2)
Note: If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
5.4.1 Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the VP-734 directly to the Ethernet port on
your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the VP-734
with the factory configured default IP address.
After connecting the VP-734 to the Ethernet port, configure your PC as follows:
1. Click Start > Control Panel > Network and Sharing Center.
2. Click Change Adapter Settings.
3. Highlight the network adapter you want to use to connect to the device and
click Change settings of this connection.
The Local Area Connection Properties window for the selected network
adapter appears as shown in Figure 7.