VP-734 - Connecting the VP-734
Always switch off the power to each device before connecting it to your
VP-734. After connecting your VP-734, connect its power and then
switch on the power to each device.
To connect the VP-734 as illustrated in the example in Figure 3, do the following:
1. Connect the video sources:
A computer graphics source to the UNIV IN 1 15-pin HD connector
A composite source (for example, a DVD player) to the UNIV IN 2
15-pin HD connector
Note that the UNIV IN 15-pin HD connector pinout is defined in
Section 5.1).
An HDMI source (for example, a BluRay player) to the HDMI 1 IN
connector
Alternatively, you can connect the DVI connector on the DVD player to the HDMI
connector on the VP-734 via a DVI-HDMI adapter
An HDMI source (for example, a DVD player) to the HDMI 3 IN connector
Alternatively, you can connect the DVI connector on the DVD player to the HDMI
connector on the VP-734 via a DVI-HDMI adapter
A DisplayPort video source (for example, a Notebook) to the DP IN
connector
Although this connecting example shows only several inputs that are
connected, you can connect all the inputs simultaneously.
2. Connect the analog stereo inputs to the 3.5mm mini jack connectors (from 1
to 7), not shown in Figure 3.
3. Connect the video outputs:
The HDMI VIDEO OUTPUT connector (can be configured via the OSD
menu, Section 7.3) to an HDMI acceptor (for example, a projector)
Note that the HDMI output can be set to output HDMI, DVI or can be set
to Auto, see Section 7.3.
To Next Page
Loading...
