9.3.1 Changing the Ethernet Settings
You can change the Ethernet parameters (DHCP box needs to be clear) by typing
the changing and clicking the Apply button. Note that:
After changing the IP number, you need to reload the Web page with the
new IP number
After changing the Subnet mask you need to turn the VP-734 power off and
then on again
9.3.2 The Information Window
To access the information window, click the icon on the lower right side of the
page. Click it once more to close the INFO window.
Figure 33: The Device Settings Page – the Information Window
9.3.3 Factory Reset
Click the Factory reset button to reset the device. The following window appears:
Figure 34: The Device Settings Page – Factory Reset
Click OK to start factory reset.
To Next Page
Loading...
