Kramer VS-44H2A

Kramer Electronics Ltd.
VS-44H2A – Operating VS-44H2A via Front Panel Buttons
15
Copying the EDID from a Connected Display
To copy the EDID from a connected display:
1. Press and hold EDID and STO simultaneously until both buttons flash.
VS-44H2A enters EDID mode and the LED Display shows the current EDID status.
2. Press one or more IN buttons (1 to 4) (or ALL).
The selected inputs on the LED Display flash.
3. Press an OUT button (1 to 4) connected to a display and press EDID .
Wait about 5 seconds for the device to copy the EDID the connected display to the
selected inputs.
Press EDID within 9 seconds to apply settings, otherwise the action times out.
Copying the Default EDID
To copy the default EDID:
1. Press and hold EDID and STO simultaneously until both buttons flash.
VS-44H2A enters EDID mode and the LED Display shows the current EDID status.
2. Press one or more IN buttons (1 to 4) (or ALL).
The selected inputs on the LED Display flash.
3. Press an OUT button (1 to 4) not connected to a display and press EDID .
Wait about 5 seconds for the device to copy the default EDID.
Press EDID within 9 seconds to apply settings, otherwise the action times out.
9
9
9
6
10
4
10
5
9
9
6
10
4
10
5
9
DRAFT