Kramer VS-44H2A

Kramer Electronics Ltd.
VS-44H2A – Using Embedded Web pages
26
Changing Device Settings and Upgrading Firmware
The Device Settings web page shows the device details, such as name, MAC address and
firmware version and also enables performing the following functions:
• Changing Ethernet Settings on page 26.
• Performing a Factory Reset on page 27.
• Performing Firmware Upgrade on page 27.
Changing Ethernet Settings
To change the Ethernet settings:
1. In the Navigation pane, click Device Settings.
The Device Settings page appears (Figure 19).
Figure 19: Device Settings Page
2. Uncheck the DHCP check box to change any of the parameters (IP Address, Netmask
and/or Gateway).
The parameters can be edited.
3. Edit IP Address, Netmask and/or Gateway Parameters and click Save Changes.
The Ethernet changes are saved.
• After changing the IP address, reload the web page with the new IP address.
• After changing the subnet mask turn the VS-44H2A power off and then on again.
• If DHCP is checked, you need to reload the web page with the new IP address.
DRAFT