Kramer VS-44H2A

Kramer Electronics Ltd.
VS-44H2A – Technical Specifications
36
Web pages:
In the Device Settings page, click Reset.
Default Parameters
Parameter
Value
Protocol:
K3000
K3000 Model Name:
V', 'S', '-', '4', '4', 'U', 'H', 'D'''
K3000 Serial Number:
00000000000001
Model name and serial number will not change back to the default status after a factory
reset.
DHCP enable:
Disable (OFF)
EDID status:
Default, all input ports use the default EDID data.
Input port HDCP:
All ON, support HDCP.
Step-In button setting:
Default, all the output checked for an input.
Video status:
Output 1 to 4 route to input 1 to 4 separately.
Audio status:
Output 1 to 4 route to digital input 1 to 4 separately.
All setups:
All empty. No preset status.
EDID data:
All input ports use the default EDID data.
V-mute:
Open the video.
Mute:
Open the audio.
Switch mode:
Manual.
Switch speed:
Ex-fast switch.
Video Priority settings
Lower input index has higher priority.
Auto Switching mode
Priority order is highest for 1 and lowest for 4
Auto Switching settings
All video inputs are routed to each of the video
outputs
Default EDID
Kramer default EDID with "monitor name"=
"VS-44H2A"
Lock EDID state
Not locked
HDCP mode
ENABLED
Video Signal loss timeout (no 5V)
0
Video Signal loss timeout (5V is on)
10 sec
New video signal gain timeout
0
Output inactivity timeout
15 min
Apply switch mode configuration on
startup
10
DRAFT