Kramer VS-88H2A

Kramer Electronics Ltd.
VS-88H2A – Operating VS-88H2A via Front Panel Buttons
17
Routing a Pattern to the Output
VS-88H2A generates 6 embedded patterns. These patterns can be routed at a resolution of
480p to any of the outputs.
Once a pattern is selected, that same pattern is routed to all the selected outputs.
A pattern is selected by pressing inputs 1 to 6 when in the Pattern mode.
1 (Color Bars)
2 (Solid Black)
3 (Solid White)
4 (Solid Red)
5 (Solid Green)
6 (Solid Blue)
Figure 6: VS-88H2A Embedded Patterns
To route a pattern:
1. Press MUTE/PATTERN .
On the front panel buttons:
• An illuminated output button means that a display is connected on that output.
• An illuminated input button indicates the current pattern selected.
On the 7-segment display:
• “P” under an output number indicates that a pattern is routed to that output.
• “-” under an output number indicates that a video input is routed to that output.
• “0” under an output number indicates that the output is muted.
2. Press an OUT (MUTE) button (1 to 8).
The 7-segment display LED, under the selected output, flashes.
Press ALL (instead of an output button) to route a pattern to all the outputs. All the
7-segment display LEDs flash.
3. Press an input button to select a pattern (see Figure 6).
The 7-segment display shows the new pattern status.
Press VIDEO, D-AUDIO or A-AUDIO to exit pattern mode.