The VS-88H2A front panel buttons enable performing the following functions:
▪ Routing Signals, on page 11.
▪ Storing and Recalling a Setup, on page 23.
▪ Setting Switching Mode, on page 24.
▪ Setting Switching Speed, on page 24.
▪ Setting HDCP, on page 24.
▪ Copying EDID, on page 25.
Routing Signals
You can switch the video and the audio signals together (AFV) or switch them separately, via
the following switching modes:
▪ Switching the Video Signal, on page 11.
▪ Routing an Audio Input to the Analog Audio Output, on page 12.
▪ Routing an Audio Input to the Digital HDMI Output, on page 14.
▪ Switching Video and Audio Signal Simultaneously, on page 15.
▪ Muting/Unmuting an Output, on page 16.
▪ Routing a Pattern, on page 17.
▪ Operating in ARC Mode, on page 18.
Switching the Video Signal
The VIDEO button on the VS-88H2A front panel enables video routing.
To switch a video input to an output:
1. Press VIDEO .
The button illuminates and the 7-segment display shows the current IN-OUT video
status.
On the front panel buttons:
• An illuminated input button means that an active signal is detected on that input.
• An illuminated output button means that a display is connected to that output.
• A flashing output button means that a non-HDCP display is connected to that output.
Note that in the case that an HDCP-encrypted input is routed through the matrix to a
non-HDCP screen, the video will not be presented and the non-HDCP screen will
turn black.
To Next Page
Loading...
