VS-88H2A – Using Embedded Web Pages
Setting the Timeout
Use the Timeout Settings web page to set the time delay to shut down if no input signal is
detected for each output and to set the auto switching time.
Always set the 5V cut-off (Disable 5V) time delay to be longer than the video signal loss
timer delay.
To set the timeout:
1. In the Navigation pane, click Timeout Settings. The Timeout Settings page appears.
Figure 39: Timeout Settings Page
2. Set the specific output delay time.
If you do not want a specific output to shut down if an input signal is not detected, check the Never box
next to the desired output.
3. Set audio support ON if you want shutdown to occur only if an audio signal is lost.
Support audio only can be used if the video and audio signals routed to an output, come from
separate sources.
If Support audio only is set to:
• ON – The audio signal routed to the output remains active when the video source (coming from
a different input) is deactivated.
• OFF – The audio signal routed to the output is deactivated together with the deactivation of the
video source (coming from a different input).
To Next Page
Loading...
