Kramer VS-88H2A

Kramer Electronics Ltd.
VS-88H2A – Technical Specifications
60
Default Parameters
Parameter
Value
Protocol:
K3000
K3000 Model Name:
V', 'S', '-', '8', '8', 'H', '2', 'A'
K3000 Serial Number:
00000000000000
Model name and serial number will not change back to the default status after a
factory reset.
DHCP enable:
Disable(OFF)
EDID status:
Default, all input ports use the default EDID data.
Input port HDCP:
All ON, support HDCP.
Step-In button setting:
Default, all the output checked for an input.
Video status:
Output 1 to 8 route to input 1 to 8 separately.
Audio status:
Output 1 to 8 route to digital input 1 to 8
separately.
Output audio volume:
Default, 50.
Output audio balance:
Default, 50.
All setups:
All empty. No preset status.
EDID data:
All input ports use the default EDID data.
Switch mode:
Manual.
Switch speed:
Ex-fast switch.
ARC or de-embedded:
De-embedded.
Video Priority settings
Lower input index has higher priority.
Auto Switching mode
Priority: Priority order is Highest for 1 and lowest
for 8
Auto Switching settings
All video inputs are routed to each of the video
outputs
Default switching mode -
manual/auto
Manual, IN1 to OUT1,etc for 2,to 8
Default EDID
Kramer default EDID with "monitor name"=
"VS-88UH2A"
Lock EDID state
Not locked
Video Signal loss timeout (no 5V)
0
Video Signal loss timeout (5V is on)
10 sec
New video signal gain timeout
0
Audio Signal loss timeout (no 5V)
0
Audio Signal loss timeout (5V is on)
5 sec
New audio signal gain timeout
0
Output inactivity timeout
15 min
Apply switch mode configuration on
startup
10