Kramer VS-88H2A

Kramer Electronics Ltd.
VS-88H2A – Using Embedded Web Pages
38
Changing Device Settings and Upgrading Firmware
The Device Settings Web page shows the device details, such as name, MAC address and
firmware version and also enables performing the following functions:
▪ Changing the Ethernet Settings on page 38.
▪ Performing a Factory Reset on page 39.
▪ Performing Firmware Upgrade on page 39.
Changing the Ethernet Settings
To change the Ethernet settings:
1. In the Navigation pane, click Device Settings. The Device Settings page appears:
Figure 24: Device Settings Page
2. Uncheck/check the DHCP check box.
3. If DHCP is unchecked, change any of the parameters (IP Address, Netmask and/or
Gateway).
4. Click Save Changes.
Note that:
• After changing the IP number, reload the Web page with the new IP address.
• After changing the Subnet mask you need to turn the VS-88H2A power off and then
on again.
• If DHCP is checked, reload the Web page with the new IP address.
Ethernet settings are changed.