Setting Switching Mode
Set the following switching modes separately for each output:
▪ Manual mode (IN 1): inputs are switched to outputs via the front panel buttons.
▪ Priority mode (IN 2): the VS-88H2A switches the source with the highest priority to
the output.
▪ Last connected mode (IN 3): the last detected active source is switched to the output.
To select the switching mode:
1. Press RCL and MUTE/PATTERN simultaneously. Both buttons illuminate.
2. Press an output button (or press ALL).
The corresponding 7-segment display LEDs flash and LOCK button flashes.
3. Press IN 1, IN 2 or IN 3.
4. Press LOCK to save the settings to that output and exit Switching mode.
Switching mode is selected.
Setting Switching Speed
Set the following switching speed modes separately for each output:
▪ Ex-Fast switch speed (IN 1).
▪ Fast switch speed (IN 2).
▪ Normal switch speed (IN 3).
To select the switching speed:
1. Press STO and MUTE/PATTERN simultaneously. Both buttons illuminate.
The 7-segment display LEDs show the current switch speed for each port.
2. Press an output button (or press ALL).
The corresponding 7-segment display LEDs flash and LOCK button flashes.
3. Press IN 1, IN 2 or IN 3.
4. Press LOCK to save the settings and exit Speed mode.
Switching speed is set.
Setting HDCP
You can enable or disable HDCP for each of the HDMI inputs.
To set HDCP on or off:
1. Press and hold EDID and RCL until both buttons illuminate.
The IN buttons indicate the HDCP status:
▪ HDCP 1.4 is enabled (on): IN button is illuminated.
▪ HDCP 2.2 is enabled (on): IN button flashes.
To Next Page
Loading...
