VS-88H2A – Using Embedded Web Pages
To set the video lost timer (when in auto-switching mode):
1. In the Navigation pane, click Timeout Settings. The Timeout Settings page appears.
2. Set the video lost timer.
The adjustment sequence presented here is only an example. You can adjust the output
settings in any other order.
If the video is lost when in the auto switching mode (Priority or Last connected) you can set the time
the device waits before it switches to the next source.
Video lost timer is set.
Setting Switching Modes
Use the Auto Switch Settings page to set the switching mode per output.
Setting to priority or last connected mode forces VS-88H2A to operate in AFV mode.
To set the switching mode:
1. In the Navigation pane, click Auto Switch Settings. The Auto Switch Settings page
appears.
Figure 40: Auto Switch Settings Page
2. Select an output and set the switching mode to Manual, Priority or Last connected:
▪ In the Manual mode (see Figure 40), the outputs are switched manually to the
selected output.
To Next Page
Loading...
