VS-88H2A – Operating VS-88H2A via Front Panel Buttons
On the 7-segment display:
• A digit (from 1 to 8) shows the input number that is currently routed to the output.
• “P” under an output number indicates that a pattern is routed to that output.
• “0” under an output number indicates that the output is muted.
2. Press an OUT (MUTE) button (1 to 8).
The 7-segment display LED, under the selected output, flashes.
Press ALL (instead of an output button) to route the selected input to all the outputs. All
the 7-segment display LEDs flash.
3. Press an IN (PATTERN) button (1 to 8).
The selected input is switched to the selected output (or to all the outputs if ALL was
pressed instead) and the 7-segment display shows the current status.
Routing an Audio Input to the Analog Audio Output
The A-AUDIO button on the VS-88H2A front panel enables to route either the analog
audio input signals or the HDMI embedded audio signals to the balanced stereo
analog audio outputs .
Generally, analog routing is enabled by pressing A-AUDIO:
▪ When it is illuminated, the HDMI input embedded audio is the audio source.
▪ When it flashes, the 3.5mm analog audio input is the audio source.
To switch an HDMI digital audio input to an analog output:
1. Press A-AUDIO .
The button illuminates (HDMI audio input to balanced audio output mode) and the
7-segment display shows the current IN-OUT analog audio status.
On the front panel buttons:
• An illuminated input button means that an active signal is detected on that input.
• Output button is not illuminated.
On the 7-segment display:
• “A” under an output number indicates that an analog audio input is the current audio
source.
• “C” under an output number indicates that ARC audio is routed to that output.
• “0” under an output number indicates that the analog audio output is muted.
• “.” under an output number indicates that the HDMI output port is in ARC mode.
• Any digit shows the HDMI audio input switching state.
2. While A-AUDIO is on, select an output button (for example, 7) and then an input button
(for example, 2). HDMI audio input 2 is routed to balanced stereo audio output 7 and on
the 7-segment display, INPUT 2 appears under OUTPUT 7.
To Next Page
Loading...
