Kramer VS-88H2A

Kramer Electronics Ltd.
VS-88H2A – Operating VS-88H2A via Front Panel Buttons
13
When switching you can also press:
▪ An output button (1 to 8) and then OUT (MUTE) to mute the selected output (turns 0).
▪ ALL (instead of an output button) and then an input button to route the selected input
to all the outputs.
All the 7-segment display LEDs flash and then display the selected input.
To switch an analog audio input to an analog output:
1. Press A-AUDIO twice.
The button flashes (analog audio input to balanced audio output mode) and the
7-segment display shows the current IN-OUT analog audio status.
On the front panel buttons:
• An illuminated input button means that a cable is connected to the 3.5mm minijack.
• An illuminated output button means that a display that supports audio is detected on
that output.
• A dark button means either that the display that is connected does not support audio
or that a display is not connected at all.
On the 7-segment display:
• “d” under an output number indicates that an embedded digital audio is currently
routed to that output.
• “C” under an output number indicates that ARC audio is routed to that output.
• “0” under an output number indicates that the analog audio output is muted.
• “.” under an output number indicates that the HDMI output port is in ARC mode.
• Any digit shows the analog audio input switching state.
2. While A-AUDIO flashes, select an output button (for example, 8) and then an input
button (for example, 1). Analog input 1 is routed to balanced stereo audio output 8 and
on the 7-segment display, INPUT 1 appears under OUTPUT 8.
When switching you can also press:
▪ An output button (1 to 8) and then OUT (MUTE) to mute the selected output (turns 0).
▪ ALL (instead of an output button) and then an input button to route the selected input
to all the outputs.
All the 7-segment display LEDs flash and then display the selected input.