Kramer VW-16

Kramer Electronics Ltd.
VW-16 – Operating and Controlling VW-16
14
To set the video source:
1. On the front panel press MENU. The menu shows.
2. Select MULTI-VIEWER > VIDEO SOURCE press Enter and define the video source
parameters based on the information in the following table:
Menu Item
Function
WIN A
INPUT 1-4.
WIN B
INPUT 1-4.
WIN C
INPUT 1-4.
WIN D
INPUT 1-4.
The multi-viewer video source is set.
Configuring the System
To set the Unit ID source:
1. On the front panel press MENU. The menu shows.
2. Select SYSTEM > UNIT ID press Enter and set the unit’s ID parameters based on the
information in the following table:
Menu Item
Function
Unit ID
Indicate the ID of the unit. ID ranges between 0-100.
The Unit’s ID is set.
To view the MAC address:
1. On the front panel press MENU. The menu shows.
2. Select SYSTEM > MAC ADDRESS press Enter.
The MAC address shows.
To configure the RCL/STO:
1. On the front panel press MENU. The menu shows.
2. Select SYSTEM > RECALL/STORE press Enter and set the unit’s ID parameters based
on the information in the following table:
Menu Item
Function
STO
(Store)
Press, followed by an Input button (1 to 4), to save the current wall
configuration.
RCL
(Recall)
Press, followed by an Input button (1 to 4), to recall a pre-saved wall
configuration.
The RCL and STO are configured.