Krone Comprima F 155 - Drive Chain for Pick-Up with Cam-Type Clutch; Overload Protection; After Baling

Operation
133
Pos: 48.63 /Übersc hriften/Überschrif ten 2/K-O/NN ach dem Pr essen @ 81\ mod_131590307 4048_78.doc x @ 708838 @ 2 @ 1
11.7 After Baling
Pos: 48.64 /Ab kürzungen /Abkürz ungen sprac hneutral/Rundb allenpressen/Co mprima V @ 25 6\mod_139 7714229979_ 0.docx @ 196267 0 @ @ 1
Comprima V
Pos: 48.65 /BA/Be dienung /Ru ndballenpresse/N ach dem Presse n CV/V @ 66\ mod_130 2516404418_78.d ocx @ 617037 @ @ 1
VPN00001_2
1
2
3
Abb.
103
The tension on the front and the rear floor conveyor must be released after baling work is
complete.
• Loosen handwheel (2) until the display of the pressure gauge (1) shows a pressure of 50
bar (Parking position)
• Tighten handwheel (2) again
The clamping cylinders of the floor conveyors are depressurised.
Pos: 48.66 /Übersc hriften/Überschrif ten 2/U-Z/UÜ berlastsich erung @ 2\ mod_12024655604 33_78.docx @ 59567 @ 2 @ 1
11.8 Overload protection
Pos: 48.67 /Übersc hriften/Überschrif ten 3/A-E/ A/Antriebskett e für Pick-Up @ 67\mod_13025 19019324_78. docx @ 61706 9 @ 3 @ 1
11.8.1 Drive Chain for Pick-up with Cam-type Clutch
Pos: 48.68 /BA/Be dienung /Ru ndballenpresse/Absic herung Üb erlastung @ 67\ mod_130 2520146803_78.d ocx @ 617093 @ @ 1
1
RPN00021
Fig.
104
CAUTION!
Damage to the machine and loss of the warranty claim
• Do not perform any manipulation on the cam-type clutch on your own
The drive is fitted with a cam-type clutch (1) as a protection against overload. This coupling has
been set in the works of the manufacturer and may not be adjusted without prior harmonisation
with the KRONE after-sales staff.
Pos: 48.69 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1