Krone Comprima F 155 - Menu 14 ISOBUS; Menu 14-9 Switching between Terminals

Terminal menus 7
Menu 14 "ISOBUS" 7.24
RP701-10 , RP701-11 , RP701-20 , RP701-21 , RP701-30 , RP701-31 , RP701-40 , RP701-41 , RP701-51
Comfort 1.0_en 57
7.24 Menu 14 "ISOBUS"
n
EQG003-014
ü The menu level has been selected, refer to page36.
 To open the menu, press
.
Æ The display shows the "ISOBUS" menu.
The "ISOBUS" menu is divided into the following sub-menus depending on the machine
configuration:
Menu Sub-menu Designation
14 ISOBUS, refer to page57
14-9 Switch between terminals, refer to page57
7.24.1 Menu 14-9 "Switching between terminals"
When switching over for the first time, the configuration of the machine is loaded into the next
terminal. The loading process may take a few minutes. The configuration is stored in the
memory of the next terminal.
Up to the next call, the machine is no longer available in the previous terminal.
When restarting, the system makes attempts to start the last used terminal. If the last used
terminal is no longer available (e.g. because it was dismounted), the restart is delayed as the
system searches for a new terminal and loads the specific menus into the terminal. Loading
may take a few minutes.
INFORMATION
This menu is only available if several ISOBUS terminals are connected.