Commissioning
86
Pos: 40.46 /Übersc hriften/Überschrif ten 3/K-O/ L/Längenanp assung @ 1\ mod_1201687632 810_78.doc x @ 53589 @ 3 @ 1
7.5.3 Length adjustment
Pos: 40.47 /BA/Sic herheit/Gele nkwelle/ACHTUNG - Geken kwelle vom Hers teller nicht spezifizi ert @ 272\ mod_140359 9419151_78.doc x @ 2052394 @ @ 1
ATTENTION!
The use of a universal shaft not approved by the manufacturer and operation at a higher PTO
speed can cause damage to the machine.
• The machine may be operated at the specified PTO speed, see the chapter "Technical
Data".
• Only the universal shaft specified by the manufacture should be used, with an appropriate
overload coupling and freewheel.
Pos: 40.48 /BA/Ers tinbetriebna hme/Rundballe npresse/Bild Gel enkwelle @ 32\ mod_12535 26913095_78.d ocx @ 314076 @ @ 1
Fig.
Pos: 40.49 /BA/Ers tinbetriebna hme/Gelenkwelle/ Großpacken pressen/Gelenkwelle ByPy/Anpass en Gelenkwelle kürzeste Stellu ng @ 17\ mod_123625 7834378_78.doc x @ 204156 @ @ 1
To adapt the length of the universal shaft, hitch the machine onto the tractor. The shortest
position of the universal shaft is reached in close cornering.
Pos: 40.50 /BA/Ers tinbetriebna hme/Rundballe npresse/Bild Gel enkwelle kürzen @ 32\ mod_125352709776 7_78.docx @ 3 14101 @ @ 1
Fig.
Pos: 40.51 /BA/Ers tinbetriebna hme/Gelenkwelle/M ähwerke/Lä ngenanpassung_ ohne Pfahlsic herung @ 375\ mod_1442 557605805_78.doc x @ 2723227 @ @ 1
The machine is connected to three-point linkage of tractor.
The length of the universal shaft (1) must be adapted.
• Disassemble universal shaft.
• Install one half on tractor side (1) and the other one on machine side (2).
• Check overlap of section tubes and guard tubes.
• Shorten section tubes and guard tubes so that the universal shaft can move freely in the
shortest operating position.
• For further procedure, please refer to the operating instructions of universal shaft
manufacturer.
Pos: 40.52 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
