Krone Comprima F 155 - Adjusting Sensor B61 Tying 1 (Passive); Sensor B13 Twine Guide Slide Position

7 Terminal menus
7.25 Menu 15 "Settings"
64
RP701-10 , RP701-11 , RP701-20 , RP701-21 , RP701-30 , RP701-31 , RP701-40 , RP701-41 , RP701-51
Comfort 1.0_en
7.25.1.4 Sensor B13 "Twine guide slide position"
For the "Net wrapping and twine tying" version
RP000-102
The sensor B13"Twine guide slide position"(2) is located on the right side of the machine
behind the side hood.
The dimension X between the switching flag (3) and the sensor (2) must be X=3mm.
 Loosen the two nuts (1).
 Loosen the two nuts (1) until the dimension X=3mm is reached.
 Tighten the two nuts (1).
INFORMATION
Correct functioning of the sensor can be tested using the terminal in menu 15-1 "Sensor test",
refer to page59.
7.25.1.5 Adjusting sensor B61 “Tying 1 (passive)”
The following positions are saved with sensorB61 “Tying 1 (passive)”:
• The feed position,
• the cutting position and
• the tying position.
15-1
1
state:
5,0V
3,5V
2,5V
1,0V
2,4V
3,5V2,4V
B61
M1
EQ003-106
ü Menu 15-1 “Sensor test” is open.
ü Sensor B61 “Tying 1 (passive)” has been selected.
Saving is only possible if the bar is inside the bottom or top rectangle of the bargraph.