Operation
170
Pos: 48.105 /Übers chriften/Zwisc henüberschrift en/U-Z/Umle nkrolle/-welle vers etzen @ 505 \mod_1499407 024583_78.doc x @ 3476938 @ @ 1
Relocating the deflection roll/shaft
Pos: 48.106 /BA /Bedienung /R undballenpresse /Umlenkroll e/-welle versetzen _Bild @ 505\ mod_149934907 0443_78.doc x @ 3476760 @ @ 1
Fig.
Pos: 48.107 /BA /Bedienung /R undballenpresse /Umlenkroll e/-welle versetzen _Text @ 505\ mod_149934 9017435_78.doc x @ 3476728 @ @ 1
If the bale formation conveyor cannot be tensioned sufficiently by means of the above-described
method, or if the bale formation conveyor tension decreases, you can relocate the deflection
roll/shaft (4) to increase the tension path.
Position [I]: Deflection roll/shaft (4) and scraper (3) in original position
Position [II]: Deflection roll/shaft (4) and scraper (3) in new position for tensioning the bale
formation conveyor
• Unlock the side hood (1) on the left side of the machine and fold it up.
• Dismount the side guard (2) on the left side of the machine.
• Remove the scraper (3) from position [I] and mount it in position [II].
• Unscrew the threaded pin to remove the adjusting ring at the screw connection of the
deflection shaft (4).
• Remove the screw connection of the deflection shaft (4).
• Remove the deflection roll/shaft (4) from position [I] and mount it in position [II].
• Slide the adjusting ring onto the deflection shaft (4) and secure with the threaded pin.
• Mount the side guard (2).
• Close the side hood (1).
Pos: 48.108 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1
To Next Page
Loading...
