Krone Comprima F 155 - Page 174

Operation
174
Pos: 48.114.1 /Ü berschriften/Z wischenüberschrift en/F-J/Fed er für Rollbode nspannung vorn einstellen @ 3 62\mod_1439 483853214_7 8.docx @ 2669082 @ @ 1
Setting the spring for bale formation conveyor tension front
Pos: 48.114.2 / BA/Bedienung /R undballenpresse/R ollboden/Bild Rollbodenvorsp annung @ 1 37\mod_135 3407640178_7 8.docx @ 1216 679 @ @ 1
COM00211_1
2
X
3
1
Z
Fig.
148
Pos: 48.114.3 / BA/Bedienung /R undballenpresse/R ollboden/F eder für Rollbo denspannung vorn einstelle n_Voraussetzung en @ 362\mo d_143948393 7982_78.docx @ 2669112 @ @ 1
Prerequisites
– To adjust the spring (1), the stop (2) must be located in position III (soft inner bale core).
– The double rocker arm (3) must rest on the stop (2) right and left (for the setting, refer to
chapter “Adapting the Soft Core”).
– The bale chamber is closed.
Pos: 48.114.4 / BA/Bedienung /R undballenpresse/R ollboden/Fe der für Rollbo denspannung vorn einstellen_Ha ndlungsschritte @ 362\m od_143948428 8517_78.docx @ 2669142 @ @ 1
• Set the dimensions X and Z on right-hand and left-hand machine side to the following
values:
Pos: 48.114.5 / BA/Bedienung /R undballenpresse/R ollboden/Fe der für Rollbo denspannung vorn einstellen_M aße V 150/18 0 (XC) @ 138 \mod_1354178 711625_78.doc x @ 1230542 @ @ 1
Comprima V 150/V 180 (XC)
X = 130 mm
Z = 690 mm
Pos: 48.114.6 / BA/Bedienung /R undballenpresse/R ollboden/Fe der für Rollbo denspannung vorn einstellen_M aße V 210 XC @ 362\mod _1439483472 892_78.docx @ 2668957 @ @ 1
Comprima V 210 XC
X = 115 mm
Z = 540 mm
Pos: 48.114.7 / BA/Bedienung /R undballenpresse/R ollboden/Fe der für Rollbo denspannung vorn einstellen_Hi nweis @ 362 \mod_1439484 495686_78.do cx @ 26691 72 @ @ 1
Note
If the rocker arms are on the same height, the springs (1) on both rocker arms must have
the same tension.
Pos: 48.115 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1