Operation
180
Pos: 48.118.8 / BA/Bedienung /R undballenpresse/R eversier en/b) Bei Ausfü hrung mit hydra ulischer Rückdre heinrichtung @ 509\mod_15 01161695926 _78.docx @ 34 93411 @ @ 1
b) For version with hydraulic reversing device
Pos: 48.118.9 / BA/Bedienung /R undballenpresse/R eversieren/H ydraulische R ückdreheinrichtu ng_Bild_Co mprima F/V @ 510\mod_15 01668253479_7 8.docx @ 34970 16 @ @ 1
Fig.
Pos: 48.118.10 /B A/Bedienung /Ru ndballenpress e/Reversieren/H ydraulisch r eversieren - Vorg ehens weise_Comprima F/V @ 510\mod_1 50166863286 8_78.docx @ 3 497044 @ @ 1
• Switch off the PTO shaft.
• Wait until all machine parts are at a standstill.
• Turn off the tractor engine. Remove the ignition key and take it with you.
• Open the stop cock (3) in the regulating valve hydraulic hose line of the reversing device.
• Turn on the tractor engine.
• To turn back the feed rotor (1) about a quarter revolution, activate the control unit in the
tractor for the reversing device 4-5 times.
• Reset the tractor with the machine.
• Depressurise the hydraulic cylinder (2).
• Turn off the tractor engine. Remove the ignition key and take it with you.
• Make certain the hydraulic cylinder (2) is completely retracted.
• Close the stop cock (3) in the regulating valve hydraulic hose line.
• Manually remove any remaining crop from the feed rotor (1) or the pick-up.
• Start the engine and turn on the PTO shaft.
Pos: 49 /Layout M odule /---------------Seitenumbruch---------------- @ 0\mod_119617531 1226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
