Krone Comprima F 155 - Page 185

Settings
185
Pos: 50.5.32 /B A/Einstellungen/R undballenpresse /Netz- und F olienbindung Ei nstellungen/ Bremskraft der Bindematerialbre mse auf Netz- oder Folien bindung einstell en_bild2 @ 512\ mod_1502893 281952_78.doc x @ 3508799 @ @ 1
COM00486
X Y
1
2
3
Fig.
156
Pos: 50.5.33 /B A/Einstellungen/R undballenpresse /Netz- und F olienbindung Ei nstellungenBi ndematerialbr emse einstell en_Ösenschraube Bremskraft_te xt_Netz- und Foli enbindung _ALLE Comprim a @ 512\mod_ 15028931658 26_78.docx @ 35 08767 @ @ 1
Chamber film wrapping: If the stretching of the film of a round bale tied with film is too strong
or too weak, it is possible to increase or reduce the brake force of the wrapping material brake
by means of the nut (3) at the eyelet bolt (1). To check the stretching, refer to the chapter
Operation, "Checking the stretching of the inserted film".
Default measure set by KRONE: X=20 mm
Net wrapping: If the net around the round bale is too loose or too tight, it is possible to set the
brake force by means of the nut (2) at the eyelet bolt (1).
Default measure set by KRONE: Y=40 mm
• Increase the dimension X for chamber film wrapping or Y for net wrapping to increase the
brake force.
• Reduce the dimension X for chamber film wrapping or Y for net wrapping to reduce the
brake force.
Pos: 50.5.34 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod _1196175311 226_0.docx @ 4165 @ @ 1