Krone Comprima F 155 - Page 239

Maintenance
239
Pos: 52.115 /Abkürz ungen /Ab kürzungen sprach neutral/Rund ballenpressen/C omprima V @ 2 56\mod_13 97714229979 _0.docx @ 19626 70 @ @ 1
Comprima V
Pos: 52.116 /BA /Wartung/Rundb allenpresse/Ket ten spannenSpa nnen Ketten hin terer Rollb odenantrieb V15 0 (XC), V 18 0 (XC), V210 XC @ 428\mo d_1455200322586 _78.docx @ 2 962993 @ @ 1
1
RPN00121
2
a
2
3
4
Fig.
205
The rear bale formation conveyor drive is on the right-hand machine side.
Checking chain tension
• Check whether the tensioned spring length a corresponds to the dimension stated below.
Type
Tensioned spring length a
Comprima V 150, V 150 XC
approx. 495 mm
Comprima V 180, V 180 XC, V 210 XC
approx. 465 mm
Correcting chain tension
• Increase or reduce the spring tension of the tension spring (2) by turning the nut (4) on the
threaded rod until a has reached the above mentioned dimension.
Pos: 52.117 /Layo ut Module /---------------Seitenumbruch--------------- - @ 0\mod_119617531 1226_0.doc x @ 4165 @ @ 1