Krone Swadro TC 880 - Troubleshooting Guide

To Next Page

To Previous Page

Malfunctions - Causes and Remedies

115

19 Malfunctions - Causes and Remedies

WARNING!

If the basic safety instructions are not followed, people may be seriously injured or

killed.

• To avoid accidents, the basic safety instructions in the chapter Safety must have been

read and followed, see chapter Safety "Basic safety instructions".

WARNING!

If the safety routines are not adhered to, people may be seriously injured or killed.

• To avoid accidents, the safety routines in the chapter Safety must be read and followed,

see chapter Safety "Safety routines".

Main Page

1 Table of Contents3
2 Foreword7
3 To this Document8
- Validity8
- Identifying Symbols in the Operating Instructions8
- Information on Direction8
- Means of Representation9
4 Safety10
- Purpose of Use10
- Intended Use10
- Service Life of the Machine10
- Basic Safety Instructions10
- Safety Routines22
- Safety Stickers on the Machine26
5 Machine Description31
- Machine Overview31
- Identification Plate32
- Information Required for Questions and Orders32
  - Contact32
- Overload Protection33
6 Technical Data of the Machine34
- Technical Data34
- Consumables36
- Tyres36
- Airborne Sound Emission36
7 Control and Display Elements37
8 Commissioning40
- General40
- First Installation40
- Preparations on Tractor41
  - Adjusting the Lower Suspension Arms41
- Connecting the Lower Link42
- Height of Tractor Lower Suspension Arms42
- PTO Shaft43
  - Length Adjustment43
- Regulating Direction of Travel44
- Checking the Locking of the Transport Position45
- Checking / Setting the Distance between Tine Arm and Lifting Cylinder46
9 Start-Up47
- Preparations on Tractor48
  - Adjusting the Lower Suspension Arms48
- Connect the Machine to the Tractor49
- Connecting the Hydraulic Lines50
- Lighting Connection51
- Connecting the Operation52
- Install the PTO Shaft53
- Using the Safety Chain54
- Swivelling Parking Support into Transport Position56
10 Driving and Transport57
- Preparations for Road Travel58
- Driving on Slopes59
- Switching off the Machine60
11 Operation61
- Removing the Tine Protections from the Tine Tips61
- Lowering Outrigger Arms into Working Position62
- Swivel Tine Arms to Working Position65
- Releasing Rotor Locking Device65
  - For Design with Collapsible Tine Arm66
- Move the Hoop Guards to the Working Position66
- Setting the Working Height67
- Adjusting the Working Width69
- Move the Hoop Guards to Transport Position70
- Swivelling Tine Arms into Transport Position71
- Raising Outrigger Arms into Transport Position73
- Protecting the Tine Tips (Transport Position and Rotary Rake Switched Off)77
- Selecing Rotor Operation78
  - For Design with Hydraulic Single-Rotor Lifting Mechanism78
  - In Case of Electro-Hydraulic Single-Rotor Lifting Mechanism Design79
- Travelling Speed und Drive Speed80
- Swathing80
12 Settings82
- Setting the Rotor Inclination83
- Fixing the Trailing Guide Wheels86
- Adjustable Throttles87
13 Maintenance88
- Spare Parts88
- Special Safety Instructions89
- Test Run89
- Maintenance Table90
- Tightening Torques91
- Deviating Torque93
  - Testing the Screws on the Tines93
  - Torque of Wheels on the Running Gear93
- Tyres94
  - Checking and Maintaining Tyres94
- Replacing the Tine Arms (in Case of Repair)96
- Replacing the Tines (in Case of Repairs)98
14 Maintenance - Lubrication Chart100
- Lubrication Points on the Universal Shafts100
- Lubrication Points on the Machine102
15 Maintenance - Hydraulic System104
- Diagram105
16 Maintenance - Gearbox108
- Main Gearbox109
17 Special Equipment110
- Tine Loss Safeguard110
- Chain for Height Restriction of Suspension Arms111
18 Placing in Storage112
- Special Safety Instructions112
- At the End of the Harvest Season113
- Before the Start of the New Season114
- Special Safety Instructions114
19 Malfunctions - Causes and Remedies115
20 Disposal of the Machine117
21 Appendix118

Krone Swadro TC 880 - Troubleshooting Guide

Table of Contents

Other manuals for Krone Swadro TC 880

Related product manuals