Commissioning
45
8.8 Checking the Locking of the Transport Position
SW9000048_1
1
2
3
Fig.14
– The machine is in transport position.
– The single-action control unit is pressurised.
– The tractor engine is switched off, the ignition key is removed and you carry it with you.
– Tractor and machine are secured against rolling away.
• Check dimension A; right and left sides of the machine
The dimension A between wedge (1) and locking (2) must be 2.5 to 3 mm.
Adjust the dimension A if it is not in the range between 2.5 to 3 mm.
To do this:
• Unscrew screws (3); move the wedge until the dimension is between 2.5 to 3 mm.
• Tighten screws (3).
To Next Page
Loading...
