Commissioning
44
8.7 Regulating direction of travel
The steering linkage has been pre-adjusted in the factory.
If a machine is hinged, make certain that the machine is driving straight ahead. On a level
street, the machine must run in the centre behind the tractor.
The steering linkage must be readjusted if the machine runs diagonally to the tractor.
Tasks on the steering may only be performed by service technicians (dealers).
1
2
SW9000028_2
Fig. 13
If the rotary rake is not running in the centre behind the tractor on a level street, this can be
controlled by adjusting the steering linkage (1).
• Loosen counter nut (2).
• Adjusting the steering linkage :
Steering rod shorter => directs machine further to the left
Steering rod longer => directs machine further to the right
• Tighten counter nut (2).
To Next Page
Loading...
