Operation
75
11.10.2 For design with hydraulic single-rotor lifting mechanism
2
1
4
SW9000010_1
II
III
I
Fig. 43
• Turn on the tractor.
• Set the switching valve (3) to central position (II).
• Raise the rotors to headland position by using the single-action control unit.
• Retract the rotor arms with the double-action control unit until the indicator arrow (4) is in
the centre between 7.8.
• Lower the rotors with the single-action control unit to release the lockings (1).
• Pull the operating cable (2) and keep it under tension to lift the lockings (1).
• Raise the rotors to transport position by using the single-action control unit.
• Release the operating cable.
SW9000035
4
Fig. 44
• To ensure a transport height of less than 4 m, retract the working width with the double-
action control unit as far as it will go (the indicator arrow (4) is just ahead of the second
screw).
• Move all hydraulic control units to neutral position.
Note
Make certain the transport locks engage correctly and the actuating rope is not tight. Perform a
visual inspection to ensure the locks (1) have engaged correctly.
To Next Page
Loading...
