7
Installing the Supply Cartridge
Figure 4: Installing the Supply Cartridge
Lock/Release
Knob
Supply Cartridge
Exit Slot
Printhead
& Rollers
1. Wind the ribbon spool on the bottom of the supply cartridge counter-clock
wise two full turns in the direction of the arrow with your finger.
2. Insert cartridge into the cartridge cavity with the lock/release knob
turned counter-clockwise and the excess material threaded in the exit slot.
3. Turn the lock/release knob clockwise to lock the cartridge into place.
4. Press FEED and you are ready to create a label.
To Next Page
Loading...