B-1
Appendix B: System Messages
The following are system messages that the K4100 will display and an explana-
tion of each message.
Cannot Save (1) There is not enough memory to save your file.
No Memory Either delete unneeded files or simplify labels by
reducing the amount of text or the number of
formatting options they contain. (2) You tried to save
a file to drive B when it is write protected.
Cartridge Empty Cartridge supply is empty. Install a new cartridge.
Font Size Too Big The point size is too large for the number of lines
you have entered. Reduce the point size or select
fewer lines.
Size Too Small Auto size has calculated a size smaller than the minimum
size of 4 pt.
Font Error! You entered the wrong number of characters for the
bar code. Check the requirements for the type of bar code
you are using and enter the correct number of characters.
No Cartridge Install a cartridge in order to print.
No Files Found You selected Open or Delete but have no files
saved in memory. You must save files before you
can open or delete them.
Printer Too Hot The printer is too hot to print labels. Wait about five
minutes and then resume printing. This message
may also appear when the printer is used in an
ambient temperature below its minimum rated
operating temperature.
Printing... The printer is printing labels. No action required.
To Next Page
Loading...