31
Printer Setup
To select the Printer Setup press the Shift and the Print key together. The
prompt below will appear. The menu options are reset, unit of measure, density,
auto off, advance cut, language, printspeed and lcd contrast.
Select Reset to restore all factory settings and defaults. To select Reset press
Enter or to exit press Delete.
The Unit of Measure function allows you to choose the unit of measure you
want to use for setting label width and margin. The options are tenths of an inch
(default) and millimeters. Select Unit from the printer setup menu by using the
cursor keys and pressing Enter. The unit menu will appear. Use the arrow keys
to move to the left of the option you want and press Enter.To accept the current
setting press Delete.
Select Density to specify the density (0-7) for printing the current label. Density
will make the label darker or lighter per unit measure. The printer displays the
current density setting and waits for your entry. Press Delete to accept the
value shown, or use the left cursor key to add density and press Enter.
If the characters are smeared on a label or are not completely filled in, you can
attempt to fix the problem by adjusting the print density. If the characters are
smeared, specify a lower number in the field; if the characters are not complete-
ly filled in, specify a higher number. You may need to adjust the density after
installing a new tape.
To Next Page
Loading...