KTM 125 - Bleeding of the Hydraulic Clutch

Repair manual KTM 125 / 200
Art No 3.206.005 -E
2-4C
Bleeding of the hydraulic clutch
– Remove screws and take off cover together with rubber bellows.
– At the slave cylinder of the clutch, remove the bleeder nipple 1.
Instead of mount the bleeder syringe
2 which is filled with SAE 10
biodegradable hydraulic oil (ex. Shell Naturelle HF-E15).
– Refill oil, until oil is discharged from the bore
3 of the master cylinder
in a bubble-free state. Make sure that the oil does not overflow.
! CAUTION !
H
AVING COMPLETED THE BLEEDING PROCEDURE, YOU HAVE TO VERIFY THAT THE OIL
LEVEL IN THE MASTER CYLINDER IS CORRECT
. FOR FILLING OF THE MASTER CYLINDER,
USE SAE 10 BIODEGRADABLE HYDRAULIC OIL ONLY (EX. SHELL NATURELLE
HF-E15); NEVER USE BRAKE FLUID NOR MIX BIODEGRADABLE HYDRAULIC OILS WITH
MINERAL OILS
.
2
1
3