16
BRAKE
SYSTEM
120
Checking
the
front
brake
fluid
level
Warning
Danger
of
accidents
Failure of the brake system.
-
If
the brake fluid level falls below the
MIN
mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding.
Warning
Danger
of
accidents
Reduced braking efficiency due to old brake fluid.
- Change the brake fluid
of
the front and rear brake according
to
the service schedule.
-
Move
the brake fluid reservoir mounted on the handlebar
to
a horizontal position.
- Check the brake fluid level in the viewer
•
When
the brake fluid level drops below the
MIN
mark:
- Add front brake fluid. (
--
p.
120)
Adding
front
brake
fluid
Warning
DanKer
of
accidents
Failure of the brake system.
-
If
the brake fluid level falls below the
MIN
mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding.
Warning
Skin
irritation
Brake fluid can cause skin irritation
on
contact.
- Avoid contact with skin and
eyes,
and
keep out of the reach
of
children.
- Wear suitable protective clothing and goggles.
-
If
brake fluid comes into contact with the
eyes,
flush the
eyes
thoroughly with water and consult a physician immediately.
Warning
DanKer
of
accidents
Reduced braking efficiency due to old brake fluid.
- Change the brake fluid
of
the front and rear brake according
to
the service schedule.
Warning
Environmental
hazard
Hazardous substances cause environmental damage.
- Oil, grease, filters, fuel, cleaners, brake fluid, etc., should
be
disposed of
as
stipulated in applicable regulations.
•
Info
I Never use
DOT
5 brake fluid!
It
is
silicone-based and purple in color. Oil seals and brake lines are not designed for
DOT
5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake
fluid
attacks paint!
Use
only clean brake fluid from a sealed container.
Preparatory
work
- Check the front brake linings. (
--
p.
117)
Main
work
-
Move
the brake fluid reservoir mounted on the handlebar
to
a horizontal position.
- Remove screws
- Remove cover with membrane
- Add brake fluid
to
level
Guideline
Dimension (brake
fluid
level below 5 mm (0.2 in)
top edge of container)
To Next Page
Loading...
Need help?
General
