18
ENGINE
•
If
the guide bolts
are
loose
or
worn:
-
Change
the sliding plate.
- Preassemble the shift shaft. (
--
p.
173)
18.4.36
Preassemblil1l
the
shill
shall
- Check clearance between the sliding plate
and
the shift quadrant.
Shift shaft - play in sliding plate/shift
0.4
...
0.8
mm
(0.016
... 0.031 in)
quadrant
•
If
the measured value
does
not meet specifications:
- Change the sliding plate.
- Secure the short
end
of the shift shaft in the bench vise.
Guideline
I
Use
soft jaws.
173
- Mount sliding plate with the guide pin facing downward
and
put the guide pin
on
the shift quadrant.
- Mount pressure spring .
- Slide
on
spring guide
,push
return spring
,with
the offset
end
facing upward,
over the spring guide
and
lift
the offset
end
over abutment bolt
304683-10
- Mount stop disk
18.4.37
Dlsassellbllna:
the
main
shall
•
00
o
' 0
304684-10
- Secure the main shaft with the toothed
end
facing downward in the vise.
Guideline
I
Use
soft jaws.
-
Remove
stop disk
and
2nd-gear fixed
gear
-
Remove
6th1!ear idler
gear
-
Remove
the split needle bearing
and
stop disk
-
Remove
lock ring
-
Remove
3rd/4th1!ear sliding gear
-
Remove
lock ring
-
Remove
stop disk
and
5th-gear idler
gear
To Next Page
Loading...
Need help?
General
