KTM 690 - TROUBLESHOOTING

MAINTENANCE WORK ON CHASSIS AND ENGINE 70
8.88Mounting oil filter x
600089-10
– Check parts for damage and wear. Replace damaged or worn parts.
– Insert the oil filter .
– Oil the O-ring of the oil filter cover and mount it with the oil filter cover .
600086-10
– Mount and tighten screws .
Specification
Screw, oil filter cover M5 6 Nm (4.43 lbf ft)
– Connect the plug .
600085-10
– Insert the oil filter .
– Oil the O-ring of the oil filter cover and mount it with the oil filter cover .
600083-11
– Mount and tighten screws .
Specification
Screw, oil filter cover M5 6 Nm (4.43 lbf ft)
– Install the fuel tank. ( P. 56)
8.89Filling up with engine oil x
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
600060-11
– Remove the screw cap  on the clutch cover and fill up with engine oil.
Engine oil 2.2 l (2.32 qt.) Engine oil (SAE 10W/60) ( P. 96)
Engine oil (SAE 20W/60) ( P. 97)
– Mount and tighten screw cap .
Danger
Danger of poisoning Exhaust gases are poisonous and can result in uncon-
sciousness and/or death.
– When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in a closed space.
– Start the engine and check that it is oil-tight.
– Check the engine oil level. ( P. 67)