INTELLIPANEL(TM) CONTROL58
C Modifying the program
Example: Modifying the lead time for the PTO shaft to stop
from the current 2-second entry to a 5-second entry.
1. Make sure the Headland Management System lock
indicator (7) is off.
2. Using the program select switch (2), choose the
program code to modify.
3. Using the scroll switch (5 or 6) to select the PTO-
related subcategory icon (9) to modify. Then touch the
edit switch (4).
Now the following editing screen appears.
4. On the editing screen, the PTO-related main category
icon (1) and subcategory icon (2), selected in the
above step 3, are automatically displayed.
Make sure the lead time icon (timer) (7) is on. Then
touch this icon.
5. Using the appearing [NUMERIC KEYPAD], enter a
new lead time (5 seconds in this example) and save
the entry.
A To change the lead time to the pre-program distance,
touch the distance/time select switch (5). The lead
time icon (7) changes to the distance icon.
The steps hereafter are the same as for the lead time
setting.
6. Touch the save switch (3).
The [Change settings. Are you sure?] message
appears.
If "YES" is selected, the program will be modified and
the previous screen will show up again.
(1) Headland Management
System lock/unlock switch
(2) Program select switch
(3) Delete switch
(4) Edit switch
(5) Scroll switch (UP)
(6) Scroll switch (DOWN)
(7) Record switch
(8) Headland Management
System lock indicator
(9) Program code indicator
(10) Subcategory icon
(1) Headland Management
System lock/unlock switch
(2) Program select switch
(3) Delete switch
(4) Edit switch
(5) Scroll switch (UP)
(6) Scroll switch (DOWN)
(7) Headland Management
System lock indicator
(8) Program code indicator
(9) PTO-related subcategory
icon
(10) Current lead time
(2 seconds)
To Next Page
