KUHN FC302G - Page 79

10. - Maintenance and storage
FC302G - FC302GI - FC352G
79
KN270BGB_F
Mower conditioner
FC302G - FC302GI - FC352G
Oil volume 2 L (0.53 US gal)
Type of oil Mineral oil (Gear oil)
Viscosity SAE80W90
Specification API-GL5 (extreme pressure)
When changing the oil, it is recommended to use either an identical mineral oil or a synthetic oil of type
PAO (Poly-Alpha-Olefine) with viscosity grade SAE75W90.
- Remove filler plug (1) and its washer.
- Place a container of sufficient capacity under drain
plug (2).
- Remove drain plug (2) and its washer.
- Allow oil to drain completely.
- Wait for dripping to stop.
- Clean and reinstall drain plug (2) and its
washer. (Replace if necessary).
- Pour the correct oil quantity and quality through the
opening of the filler plug (1).
- Clean and reinstall filler plug (1) and its
washer. Replace if necessary.
- Check side bevel gearbox oil level:
• Remove filler plug (1) and its washer.
• The oil level must reach the lower edge of level
hole (1).
• Top up if necessary.
• Clean and reinstall filler plug (1) and its
washer. Replace if necessary.
2
1