FC302G - FC302GI - FC352G
78
10. - Maintenance and storage
KN270BGB_F
Mower conditioner
The side angle gearbox
When changing the oil, it is recommended to use either an identical mineral oil or a synthetic oil of type
PAO (Poly-Alpha-Olefine) with viscosity grade SAE75W90.
- Remove breather plug (1) and its seal.
- Place a container of sufficient capacity under drain
plug (2).
- Remove drain plug (2) and its washer.
- Allow oil to drain completely.
- Wait for dripping to stop.
- Clean and reinstall drain plug (2) and its
washer. (Replace if necessary).
- Pour the correct oil quantity and quality through the
opening of the filler plug (1).
- Clean and reinstall breather plug (1) and its
seal. Replace if necessary.
- Check oil level in lower gearbox:
• Remove level plug (3).
• The oil level must reach the lower edge of level
hole (3).
• Top up if necessary.
• Clean and reinstall level plug (3) and its
seal. Replace if necessary.
Before draining oil, operate the machine for a
few minutes so that the oil warms up.
To Next Page
Loading...
