11. - Troubleshooting guide
FC302G - FC302GI - FC352G
97
KN270BGB_F
Mower conditioner
Obstruction of
conditioning rotor.
Insufficient rotor speed
(rotational frequency).
Check that the rotor drive
belts are correctly
tensioned.
Too low PTO speed
(rotational frequency).
Increase the PTO speed
and check that the chosen
input speed corresponds
to the nominal tractor PTO
speed.
Swath shields too closed. Open swath shields.
Belts stretched or worn. Tighten or replace the
belts
Badly shaped windrows. Belts slip. Retension belts.
Too low PTO speed
(rotational frequency).
Increase the PTO speed
and check that the chosen
input speed corresponds
to the nominal tractor PTO
speed.
Incorrectly adjusted swath
shields.
Adjust both swath shields.
Machine requires too
much pull power.
Too much cutterbar down
pressure.
Adjust the mowing unit
ground pressure.
Frequent knife breakage. Incorrect cutting height. Adjust the cutting height.
Too much cutterbar down
pressure.
Adjust the mowing unit
ground pressure.
Excessive ground speed. Reduce groundspeed.
Problem Cause Remedy
To Next Page
Loading...
