79 / 125Issued: 16.03.2016 Version: MA KR 300 470-2 PA V5
10 Appendix
Section 5 Fire-fighting measures
Section 6 Measures after unintended release
Section 7 Handling and storage
Ingestion: Do not induce vomiting. If the person is unconscious, do not
give anything by mouth. Consult a physician immediately.
Notes to physician: Treatment should in general be symptomic and directed at
relieving any effects.
Note regarding high-pressure applications.
Injection into the skin due to contact with a product under high
pressure constitutes a major medical emergency. Within a few
hours the tissue swells up and becomes discolored and
extremely painful, with severe subcutaneous necrosis.
Surgical treatment is absolutely imperative. Comprehensive
opening of the wound and the tissue beneath it is necessary in
order to reduce tissue loss and to prevent or limit lasting dam-
age. The high pressure can cause the product to penetrate
extensive areas of tissue layers.
Suitable extinguishing agents: In the event of a fire: use water spray (mist), foam, dry chemi-
cals or CO2.
Unsuitable extinguishing
agents:
Do not use water jets.
Special instructions for extin-
guishing work:
Contaminated extinguishing water must be collected separately
and prevented from entering the drainage system.
Hazardous decomposition
products:
Decomposition products include various oxides (e.g. carbon
oxides).
Unusual fire/explosion haz-
ards:
This product is not inherently explosive in accordance with the
applicable rules.
Special fire-fighting measures: -
Protection of fire-fighters: Fire-fighters must wear self-contained positive pressure breath-
ing apparatus (SCBA) and full protective gear.
Personal safety precau-
tions:
In case of spillage, isolate the hazard area. Avoid contact with
the hazardous substance and avoid inhaling vapors. Ensure
adequate ventilation. Where there is insufficient ventilation,
wear suitable respiratory equipment. Use suitable protective
equipment.
Environmental protection
measures:
Prevent the product from entering the drainage system, surface
waters and soil. Notify the competent authorities, if required.
Large spills: Stop the leak if you can do so without risk. Remove container
from spill area. Flush spilled material into a wastewater treat-
ment plant. Contain spilled material using a non-combustible
absorbent (e.g. sand, soil, vermiculite, diatomaceous earth) and
collect in the containers provided. Disposal should be entrusted
to a recognized waste disposal company. Contaminated absor-
bents can be just as dangerous.
Small spills: Stop the leak if you can do so without risk. Remove container
from spill area. Dilute with water and mop up, or add absorbent
material and place the substance in a suitable container for dis-
posal. Disposal should be entrusted to a recognized waste dis-
posal company.
To Next Page
Loading...
